New mpower Edge firmware breaks installer

[mutton74]

Just installed new firmware (mPower™ Edge Intelligence 5.1.5) on a MTCDT-247A (AEP AUS)

and tried the installer script (which ran fine on the previous 1.4.17 firmware I had on it) and get the following error

installer.sh: line 733: /var/config/lora/global_conf_src: Permission denied
FATAL ERROR: could not obtain gateway id, Lora card not found

even though the card shows up within the Multitech GUI no worries

any ideas?

regards
Paul

[tenwalls]

Paul - did you persist through this error

[mutton74]

Yes, just run the installer with sudo